Emulex LightPulse LPe1105-M4 HBA Przewodnik Instalacji Pobierz pdf (Strona 175)

(CLARiiON only): Linux Navisphere Agent/CLI limitation with fdisk on CLARiiON

175

Special Instructions

Disabling the Navisphere Agent service

After the Naviagent registers the host with the CLARiiON system,

the service may be disabled so that it does not start upon reboot. This

may be performed manually or by using the curses-based setup tool.

To peform this manually:

If the Unisphere Host Agent or Navisphere Agent/CLI is installed

and enabled on the host, stop the Unisphere Host Agent or

Navisphere Agent service by typing one of the following commands:

• For the Unisphere Host Agent:

/etc/init.d/hostagent stop

service hostagent stop

• For the Navisphere Host Agent:

/etc/init.d/naviagent stop

service naviagent stop

Issuing a Navisphere Agent stop command

On RHEL, the Naviagent service may be stopped with one of the two

following commands and then the fdisk/mkfs commands may be

rerun:

service naviagent stop

/etc/rc.d/init.d/naviagent stop

On SLES, the Naviagent service may be stopped with the following

command and then the fdisk/mkfs commands may be rerun:

/etc/init.d/naviagent stop

Removing the Naviagent/CLI RPM

The Naviagent/CLI RPM may be removed from the system after it

has been used for the initial set-up and registration of the host on the

CLARiiON system.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 181 182

Brak uwag

Emulex LightPulse LPe1105-M4 HBA Przewodnik Instalacji Strona 175