Emulex LP9802DC Instrukcja Użytkownika Pobierz pdf (Strona 31)

Driver for HP-UX - Troubleshooting Section Page 28

lpfcN: 42 : Xmit sequence completion error

DESCRIPTION: A XMIT_SEQUENCE command completed with a status error in the IOCB. The IOCB

status, the IOCB iotag, the IOCB parameter error, as well as the PortID this command was directed to

are recorded. The driver attempts to recover by creating a new exchange to the remote device.

LOG: WARNING IP verbose fcxmitb.c

ACTION: If there are many errors to one device, check physical connections to Fibre Channel network

and the state the remote PortID is in.

lpfcN: 43 : Stray CreateXRI completion

DESCRIPTION:Received a CREATE_XRI command completion without issuing a corresponding

CREATE_XRI Command (based on the iotag field in the CREATE_XRI_CR iocb). The IOCB command

and iotag used to match are recorded.

LOG: ERROR always fcxmitb.c

ACTION: This error could indicate a software driver or firmware problem. If problems persist report

these errors to customer service.

lpfcN: 43 : Stray CreateXRI completion

DESCRIPTION: Received a CREATE_XRI command completion without issuing a corresponding

CREATE_XRI command (based on the IOTAG field in the CREATE_XRI_CR IOCB). The IOCB

command and IOTAG used to match are recorded.

LOG: ERROR always fcxmitb.c

ACTION: This error could indicate a software driver or firmware problem. If the problems persist, report

these errors to Technical Support.

lpfcN: 44 : Adapter failed to initialize

DESCRIPTION: The host adapter failed to initialize properly. The status register is recorded.

LOG: ERROR always lp6000.c

ACTION: This error usually indicates a hardware problem with the adapter, run diagnostics.

lpfcN: 45 : Adapter initialization failed, Mailbox command

DESCRIPTION: The host adapter failed to initialize properly because a mailbox command failed. The

mailbox command and mailbox status value are recorded.

LOG: ERROR always lp6000.c

ACTION: This error usually indicates a hardware problem with the adapter, run diagnostics.

lpfcN: 46 : RUN_BIU_DIAG failed

DESCRIPTION: The host adapter failed to initialize properly because a PCI bus DMA test failed.

ERROR always lp6000.c

ACTION: This error usually indicates a hardware problem with the adapter, run diagnostics.

1 2 ... 26 27 28 29 30 31 32 33 34 35

Brak uwag

Emulex LP9802DC Instrukcja Użytkownika Strona 31