Emulex LP9802DC Instrukcja Użytkownika Pobierz pdf (Strona 24)

Driver for HP-UX - Troubleshooting Section Page 21

Platform Independent Errors (001 - 099)

lpfcN: 1: Stray ELS completion

DESCRIPTION: Received an ELS command completion without issuing a corresponding ELS command

(based on the IOTAG field in the CMD_ELS_REQUEST_CR IOCB). The IOCB command and IOTAG

are used to match are recorded.

LOG: ERROR always fcelsb.c

ACTION: This error could indicate a software driver or firmware problem. If the problems persist, report

these errors to Technical Support.

lpfcN: 2: ELS [command response] completion error

DESCRIPTION: An ELS command completed with a status error in the IOCB. The IOCB command,

IOCB status, IOCB parameter error, as well as the PortID this ELS command was directed to are

recorded. This is only a warning. It could mean:

• The Fibre Channel device on the network is not responding.

• The Fibre Channel device is not an FCP target.

The Fibre Channel driver will automatically retry this ELS command if needed.

LOG: WARNING ELS verbose fcelsb.c

ACTION: If the ELS command is a PLOGI or PRLI, and the destination PortID is not an FCP target, no

action is needed. Otherwise, check the physical connections to the Fibre Channel network and the state

of the remote PortID.

lpfcN: 3: Device Discovery completion error

DESCRIPTION: This indicates that an uncorrectable error was encountered during device (re)discovery

after a link up. Fibre Channel devices will not be accessible if this message is displayed. The location

within the driver is recorded.

LOG: ERROR always fcelsb.c

ACTION: Reboot the system. If the problem persists, contact Technical Support. Run with verbose mode

on for more details.

lpfcN: 4: Device Discovery completes

DESCRIPTION: This indicates successful completion of device (re)discovery after a link up. The location

within the driver is recorded.

LOG: WARNING DISCOVERY verbose fcelsb.c

ACTION: none needed.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 34 35

Brak uwag

Emulex LP9802DC Instrukcja Użytkownika Strona 24