Emulex 110 Instrukcja Użytkownika Strona 62

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 61
OneCommand Manager for VMware vCenter User Manual Page 57
Test Pattern
Enter a custom test pattern to be used in tests that transfer data. The test pattern can be up to eight
hexadecimal bytes.
Test Status
The Test Status area shows how many completed cycles of each test ran, as well as the number of
errors.
To run loopback tests:
1. From the Emulex Device Management tree view, select the OneConnect adapter physical port
on which you want to run the loopback test.
2. Select the Diagnostics tab. In the Loopback Test area of the dialog box, choose the type of
loopback test you want to run and define the loopback test parameters.
3. Click Start Test. The following warning appears:
Figure 53: Diagnostic Tests warning
4. Click Yes. A progress bar shows that the test is running.
Periodic test feedback, consisting of the current loopback test/cycle plus the completion status
of each type of test, is displayed in the Test Status section of the dialog box. Click Show Test
Logs to view and save the log file (Figure 54 on page 58).
Using Beaconing
The beaconing feature enables you to force a specific adapter’s LEDs to blink in a particular sequence.
The blinking pattern acts as a beacon, making it easier to locate a specific adapter among racks of other
adapters.
When you enable beaconing for OneConnect adapters, the two LEDs blink rapidly in unison until you
disable beaconing.
To enable or disable beaconing:
1. From the Emulex Device Management tree view, select the adapter port whose LEDs you want
to set.
2. Select the Diagnostics tab and click Beacon On or Beacon Off.
Note: You must insert a loopback plug-in the selected adapter before running an External
Loopback test. Also, you must ensure that the NIC function of the port goes to a link
up state.
Note: The beaconing radio buttons are disabled if the selected adapter does not
support beaconing.
Przeglądanie stron 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 118 119

Komentarze do niniejszej Instrukcji

Brak uwag